• Configuring a Brocade Switch for Access Gateway (AG) Mode What is Access Gateway Mode? Access Gateway mode is useful when you need to add more ports to your fabric without the additional complexity of using additional zoning configurations or additional domains.  It allows us to configure an F port as N port. Other Useful Brocade related posts FOS CLI Reference Guide Automating Config Zone … Continue reading Configuring a Brocade Switch for Access Gateway (AG) Mode
  • Web interface disabled on brocade switch I ran into an issue where one of our brocade switches was inaccessible via the web browser. The error below was displayed when connecting to the IP: Interface disabled This Interface (10.2.2.23) has been blocked by the administrator. In order to resolve this, you’ll need to allow port 80 traffic on the switch.  It was … Continue reading Web interface disabled on brocade switch
  • Disabling Telnet on Brocade Switches We were recently directed by audit requirements to disable telnet access on all of our brocade switches.  We’re going to use ssh only for remote access.   The steps for disabling telnet aren’t obvious although it’s not difficult to do.  I’ve outlined two different procedures below for disabling telnet on FOS, as it’s different if you’re running … Continue reading Disabling Telnet on Brocade Switches
  •  

     

     

     

     

     

     

     

     

     

     

     

     

    Advertisements

    Like this:

    %d bloggers like this: